Hi!
Sorry, I'm writing in english, because of my poor swedish.
I have bought old Köpings VF10 milling machine.
But I had bad luck, because machine fell to the ground, when it was lifted to truck..
Well, I suppose it was near to ground, because it still looks like milling machine.
Some cranks are broken, and oils came out. That is what I can see from outside.
And one cable is broken.. cable from control panel to switch cabinet.
Wires are numbered, so that is not a problem.
But there is something wrong in side of switch cabinet too, and that is why I'd need wiring diagram for the machine.
Would I have enough luck to find wiring for this machine from somewhere..?
Btw, there is so many oil checkpoints.. but so far I have found only one oil cap for filling..?