Alla mått finns i länken jag skickade.
Precis alla mått.
Valve clearance inspection and adjustment must
be done with the engine cold.
Remove the
cylinder head cover, and set the
piston at top dead center of the compression
stroke (both valves will be fully closed).
1. Measure the clearance between the rocker
arm and the
valve stem with a feeler gauge.
Intake: 0.10-0.15 mm
Exhaust: 0.15-0.20mm
To adjust
valve clearance, hold the
rocker arm pivot and loosen the pivot
lock nut.
2. Turn the rocker arm pivot to obtain the
specified clearance.
3. Hold the rocker arm pivot and tighten the pivot
lock nut.
4. Recheck the clearance and readjust if necessary.
5. Install the cylinder head cover.
Bifogar en manual
Du har inte behörighet att öppna de filer som bifogats till detta inlägg.