Tack Lars!
i am from USA, so please excuse me writing in english and reply in Swedish, i will understand
But even after reading the manual i am confused: is there no way to adjust the front to back angle on the knife relative to the guards and the bar? An Aktiv Sprinter was more or less abandoned on our neighbors' farm, and i would like to get it into working order, but it has snapped 4 knives, all at the same location near the connection to the
vevstake, and obviously several times for each knife as all but one have been welded and broken again. Clearly, the points of the knives have been jamming against and even cutting into the top of the guards and this has been the cause of the broken knives... it must have been cutting incredibly poorly, too
But looking at the machine i have not yet found any way to adjust the knife angle relative to the guards... and nothing looks bent or terribly worn... so my only other thought is if someone once replaced the guards with the wrong type of a different angle... Any help is greatly appreciated, thank you!