Maskinisten

Dear experts,
Now spring has come and we started to overhaul our favorite Akerman.
Please tell how to knock the old spherical bearings ears? First warm? Or you can cut it?

Kan någon översäta

Kära Expert,
Nu har våren kommit och vi reparerar vår älskade nachalikapitalny Ackerman.
Berätta hur att slå de gamla sfäriska lager öron? Värme? Eller skär?

Well,,, either you can use heat and a pullers or simply grind a slot in an angle across the bushing using a pneumatic straight grinder and then hammer it out when tension has released.

Better ideas anyone?

/Christer

krokodilen skrev:Well,,, either you can use heat and a pullers or simply grind a slot in an angle across the bushing using a pneumatic straight grinder and then hammer it out when tension has released.

Better ideas anyone?

/Christer

no Im agree. thats a way to do it.

I hope you have taken out the pressure locking springs? The bearing shoudnt be so hard to knock out.....

Er det ikke at vanlig lenklager dette da???

Translating from #1 (översättning av inlägg #1):

Han undrar hur man får bort ledlagren, värme eller skära bort dom?


My answer: press it or cut it through carefully on one or two places then press it through.

Men där sitter väll inga ledlager! bara vanliga stålbussningar skulle jag tro
bara att snitta upp o slå ut dessa!

Jovisst sitter där länklager. Med låsringar på varje sida.Det är ju en ÅKERMAN!!

/Anton!!

--------

Remover som grease,take out one of the two lpcking springs. Knock the bearing out.

Put the new bearing in the freezer a couple of hours before you mount it in place,it make it easier too mount.

Tack herrarna hjälpte ditt råd oss.