I'm looking some advice from the experts on here as you lot seem to know a thing or two...
I was pulling out tree's and tracking backwards as there was overhead wires and I needed to keep the boom down...The RH track stopped working and made a terrible rasping noise.
I thought it could be the chain drive had snapped or stripped a sprocket.
I got her home by lifting her on one side with the dipper and using the other track.
Today I've removed the chain guard plate and the sprocket is wobbling about and rasping the gears.
I got the chain drive split and removed the small sprocket and it is either the output shaft snapped, the brake side bearing, or worst case scenario, the shoulder that holds the bearing...nightmare!!
I need to get the track off to remove the gearbox plate but can only identify one track pin with a "dimple"...How do I remove it?
How do I remove the output shaft?
How do I remove the pulley wheel for the brakes?
Plus any advice at all on how to do this would be greatly appreciated..
Thanks in advance