• FC0.02 or FC 0.03
This is a malfunction of the electronic components within Puma 2, which may exceptionally occur when switching on.
In this case the following procedure is recommended: Clean the
battery for a few minutes, clean battery terminals and
cable lugs. Measure the battery
voltage, it must be higher than 11 Volt, then reconnect the battery.
Initialize Puma 2 the above mentioned codes must have been erased.
If this is not the case replace the box.
• FC 1.1 or 1.2
Detection of a blown fuse
Beroende av version på Puman
FC 1.03 Problems with main power supply (
fuse FU3) 4 x
Det finns två sorters människor, de som får saker gjorda och de som tar åt sig äran.
Det gäller att tillhöra den förstnämnda för i den är det lägre konkurrens!
Dubito, ergo cogito, ergo sum